Change a Propane Tank
Forklifts powered by propane are common in warehouse settings. These forklifts have a propane mount located at the rear of the driver. These tanks have to be replaced from time to time because they have limited lifespans. Forklift drivers should always utilize care when handling propane tanks. Compressed gases are really hazardous, especially because the gas is flammable. Always use care when replacing and removing propane tank to avoid injury.
1 If there is a need to replace the propane tank, the first step is to stop the lift truck, then turn the tank valve off. The lift truck must be left on until the engine dies. This procedure burns the gas off in the transfer hose that connects the tank and the engine. Prior to taking the next steps, put on the correct safety equipment, such as insulated gloves made of either neoprene or leather. It is very essential for you to protect your skin from touching the compressed gas, that is extremely cold.
2 The hose of the tank has to be disconnected, followed by removing the tank from its holding straps. When you put in a new tank, tighten the nut to reattach the holding straps and to reattach the hose at the valve of the tank.
3 You can inspect for leaks by applying soapy water to the valve and opening it slightly. Leaking gas will cause bubbles to froth around the value. If this occurs, check the valve area and the connection hose at the nut. The connecting nut should be re-tightened if you detect any leaks around the valve area, and afterward perform the leak checking process all over again. Persistent leaks mean that both the nut and connecting hose must be replaced. Nonetheless, if replacing the nut and hose still does not stop the leak, the tank would need to be replaced.
4 Open the valve all the way to allow the gas to fill the connecting hose. After that you could start the lift truck and resume operating.